Payment Method
MAX3222ECDWR
3- to 5.5-V dual channel 500kbps RS-232 line driver/receiver with +/-15-kV IEC-ESD protection
-
Manufacturer:
-
Mfr.Part #:
MAX3222ECDWR
-
Datasheet:
-
Type:
Transceiver
-
Protocol:
RS232
-
Number of Drivers/Receivers:
2/2
-
Duplex:
Full
-
EDA/CAD Models:
Availability: 3219 PCS
Please fill in the short form below and we will provide you the quotation immediately.
MAX3222ECDWR General Description
The MAX3222E consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND).
The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The device operates at typical data signaling rates up to 500 kbit/s and a maximum of 30-V/µs driver output slew rate.
The MAX3222E can be placed in the power-down mode by setting the power-down ( PWRDOWN) input low, which draws only 1 µA from the power supply. When the device is powered down, the receivers remain active while the drivers are placed in the high-impedance state. Also, during power down, the onboard charge pump is disabled; V+ is lowered to VCC, and V– is raised toward GND. Receiver outputs also can be placed in the high-impedance state by setting enable ( EN) high.
Key Features
- ESD Protection for RS-232 bus pins
- ±15-kV Human-body model (HBM)
- ±8-kV IEC61000-4-2, Contact discharge
- ±15-kV IEC61000-4-2, Air-gap discharge
- Meets or exceeds the requirements of TIA/EIA-232-F and ITU v.28 standards
- Operates with 3-V to 5.5-V VCC supply
- Operates up to 500 kbit/s
- Two drivers and two receivers
- Low standby current . . . 1 µA Typ
- External capacitors . . . 4 × 0.1 µF
- Accepts 5-V logic input with 3.3-V supply
- Alternative high-speed pin-compatible device (1 Mbit/s) for SNx5C3222E
Specifications
Category | Integrated Circuits (ICs)InterfaceDrivers, Receivers, Transceivers | Series | - |
Type | Transceiver | Protocol | RS232 |
Number of Drivers/Receivers | 2/2 | Duplex | Full |
Receiver Hysteresis | 300 mV | Data Rate | 500kbps |
Voltage - Supply | 3V ~ 5.5V | Operating Temperature | 0°C ~ 70°C |
Mounting Type | Surface Mount | Base Product Number | MAX3222 |
Service Policies and Others
After-Sales & Settlement Related
For alternative payment channels, please reach out to us at:
[email protected]Shipping Method
AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.
365-Day Product
Quality Guarantee
We promise to provide 365 days quality assurance service for all our products.
Availability: 3219 PCS
+BOMQty. | Unit Price | Ext. Price |
---|---|---|
1+ | - | - |
The prices below are for reference only.
All bill of materials (BOM) can be sent via email to [email protected], or fill below form to Quote for MAX3222ECDWR, guaranteed quotes back within 12hr.
Top Sellers
-
SN65HVD230DR
TI
1000+ $0.403
-
SN75176BP
Texas Instruments
1000+ $0.309
-
PCF8574AN
TI
8-bit 2.5- to 5.5-V I2C/SMBus I/O expander with interrupt
-
MAX232N
Texas Instruments
Dual Transmitter/Receiver RS-232 16-Pin PDIP Tube
-
TCA6424RGJR
Texas Instruments, Inc
24-bit translating 1.65- to 5.5-V I2C/SMBus I/O expander with interrupt, reset & config registers