This website uses cookies. By using this site, you consent to the use of cookies. For more information, please take a look at our Privacy Policy.

MAX3223MDBREP

2/2 Transceiver Full RS232 20-SSOP

MAX3223MDBREP General Description

The MAX3223 consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The device operates at typical data signaling rates up to 250 kbit/s and a maximum of 30-V/µs driver output slew rate.

Flexible control options for power management are available when the serial port is inactive. The auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is set low and EN is high, both drivers and receivers are shut off, and the supply current is reduced to 1 µA. Disconnecting the serial port or turning off the peripheral drivers causes auto-powerdown to occur. Auto-powerdown can be disabled when FORCEON and FORCEOFF are high. With auto-powerdown enabled, the device is activated automatically when a valid signal is applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than -2.7 V, or has been between -0.3 V and 0.3 V for less than 30 µs. INVALID is low (invalid data) if the receiver input voltage is between -0.3 V and 0.3 V for more than 30 µs.

max3223mdbrep max3223mdbrep

Key Features

  • Controlled Baseline
    • One Assembly
    • One Test Site
    • One Fabrication Site
  • Extended Temperature Performance of up to -55°C to 125°C
  • Enhanced Diminishing Manufacturing Sources (DMS) Support
  • Enhanced Product-Change Notification
  • Qualification Pedigree(1)
  • RS-232 Bus-Pin ESD Protection Exceeds ±15 kV Using Human-Body Model (HBM)
  • Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards
  • Operates With 3-V to 5.5-V VCC Supply
  • Operates up to 250 kbit/s
  • Two Drivers and Two Receivers
  • Low Standby Current . . . 1 µA Typical
  • External Capacitors . . . 4 × 0.1 µF
  • Accepts 5-V Logic Input With 3.3-V Supply
  • Alternative High-Speed Pin-Compatible Device (1 Mbit/s)
    • SNx5C3223
  • APPLICATIONS
    • Battery-Powered Systems
    • PDAs
    • Notebooks
    • Laptops
    • Palmtop PCs
    • Hand-Held Equipment

(1) Component qualification in accordance with JEDEC and industry standards to ensure reliable operation over an extended temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold compound life. Such qualification testing should not be viewed as justifying use of this component beyond specified performance and environmental limits.

max3223mdbrep max3223mdbrep
max3223mdbrep max3223mdbrep

Specifications

Category Integrated Circuits (ICs)InterfaceDrivers, Receivers, Transceivers Mfr Texas Instruments
Series - Package Tape & Reel (TR)Cut Tape (CT)Digi-Reel®
Product Status Active Type Transceiver
Protocol RS232 Number of Drivers/Receivers 2/2
Duplex Full Receiver Hysteresis 500 mV
Data Rate 250kbps Voltage - Supply 3V ~ 5.5V
Operating Temperature -55°C ~ 125°C Mounting Type Surface Mount
Package / Case 20-SSOP (0.209", 5.30mm Width) Supplier Device Package 20-SSOP
Base Product Number MAX3223

Service Policies and Others

After-Sales & Settlement Related

payment Payment

Payment Method

hsbc
TT/Wire Transfer
paypal
Paypal
wu
Western Union
mg
Money Gram

For alternative payment channels, please reach out to us at:

[email protected]
shipping Shipping & Packing

Shipping Method

fedex
Fedex
ups
UPS
dhl
DHL
tnt
NTN
Packing

AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.

warranty Warranty

We promise to provide 365 days quality assurance service for all our products.

Ratings and Reviews

More
M
M**r 04/11/2023

White and blue are extremely bright, this is awesome

2
Z
Z**e 12/22/2022

It came in a quality package, without damage. Everything is fine. I recommend.

7
L
L**n 11/05/2022

Leds of medium quality. Previously ordered here the same, the quality was super, but they cost three times more...

4
J
J**n 02/11/2021

Received!!! Delivery to ulyanovsk 49 days.

10

Reviews

You need to log in to reply. Sign In | Sign Up

Availability: 6005 PCS

+BOM
Qty. Unit Price Ext. Price
1+ - -

The prices below are for reference only.