Payment Method
![hsbc](/img/service-policies-hsbc.png)
![paypal](/img/service-policies-paypal.png)
![wu](/img/service-policies-wu.png)
![mg](/img/service-policies-mg.png)
I2C Interface 400kHz 5.5V 24-Pin TQFN EP
QFNManufacturer:
Mfr.Part #:
MAX7324ATG
Datasheet:
Programmable:
Not Verified
Number Of I/O:
8
Interface:
I²C
Interrupt Output:
Yes
EDA/CAD Models:
Please fill in the short form below and we will provide you the quotation immediately.
The MAX7324 2-wire serial-interfaced peripheral features 16 I/O ports that are divided into eight push-pull outputs and eight inputs. Each input features selectable internal pullups, overvoltage protection to +6V, and transition detection with an interrupt output. All input ports are continuously monitored for state changes (transition detection). The interrupt is latched, allowing detection of transient changes. Any combination of inputs can be selected using the interrupt mask to assert the active-low INT output. When the MAX7324 is subsequently accessed through the serial interface, any pending interrupt is cleared. The push-pull outputs are rated to sink 20mA and are capable of driving LEDs. The active-low RST input clears the serial interface, terminating any I2C communication to or from the MAX7324. The MAX7324 uses two address inputs with four-level logic to allow 16 I2C slave addresses. The slave address also enables or disables internal 40kΩ pullups in groups of four ports. The MAX7324 is one device in a family of pin-compatible port expanders with a choice of input ports, open-drain I/O ports, and push-pull output ports (see Table 1 in the full data sheet).
The MAX7324 is available in 24-pin QSOP and TQFN packages, and is specified over the -40°C to +125°C automotive temperature range.
Category | Integrated Circuits (ICs)InterfaceI/O Expanders | Series | - |
Programmable | Not Verified | Number of I/O | 8 |
Interface | I²C | Interrupt Output | Yes |
Features | POR | Output Type | Push-Pull |
Current - Output Source/Sink | 20mA | Clock Frequency | 400 kHz |
Voltage - Supply | 1.71V ~ 5.5V | Operating Temperature | -40°C ~ 125°C |
Mounting Type | Surface Mount | Base Product Number | MAX7324 |
After-Sales & Settlement Related
Payment Method
For alternative payment channels, please reach out to us at:
[email protected]Shipping Method
AVAQ determines and packages all devices based on electrostatic discharge (ESD) and moisture sensitivity level (MSL) protection requirements.
365-Day Product
Quality Guarantee
We promise to provide 365 days quality assurance service for all our products.
Qty. | Unit Price | Ext. Price |
---|---|---|
1+ | - | - |
The prices below are for reference only.
All bill of materials (BOM) can be sent via email to
[email protected],
or fill below form to Quote for MAX7324ATG, guaranteed quotes back within
12hr.
MAX9130EXT-T
Maxim Integrated
Precise data reception guaranteed with this advanced single receiver IC
MAX5064
MAXIM
MAX16818
MAXIM
max16818 1.5mhz, 30a high-efficiency led driver with rapid led current pulsing first high-efficiency, high-power led driver that enables rapid transient response, accurate led current regulation, pwm and analog dimming
MAX3950EGK
MAXIM
LVDS Deserializer 622Mbps/10000Mbps 0.25V 68-Pin QFN EP
MAX3802
MAXIM
IC DRIVER 1/0 68TQFN